CHANGING THE BASE PLATE CAPACITORS
HARDWARE TUTORIALS
PHOTOS electrolytic capacitor "INFLATION"
TELL A
CONDENSER
CONDENSER
MOTHERBOARD INFLATION OR BURNED
The most common way to see if the capacitors are causing inessive or failure in the PC is looking at them physically, we can find two models with problems typical of a capacitor would be the typically inflated as the other would be the loser liquid electrolyte.
THESE ARE THE SYMPTOMS
MOTHERS HAVE THE PLATES
THAT HAVE A BAD CONDENSER
The motherboard does not pass the POSTT
the memory test fails
THE
computer does not boot
computer does not boot
Ha and restarting it several times
often blue screens (BSOD) sudden.
High hard disk activity.
CPU temperature is higher than normal
Voltages CPU, RAM or other parts equivocal and out of range.
After a BSOD (blue screen)
have to unplug the power and reconnect the PC to boot again.
MATERIALS WE NEED TO CHANGE
CAPACITORS ARE:
A WELDER FROM 25 TO 30 W
CAPACITORS: SEARCH SIMILAR OR BETTER
WELDING WIRE
A CLAMP PLIERS
To improve performance it is recommended to change all capacitors that the motherboard has to be of a diameter greater than 6mm the others mostly affect the performance and return on board.
The procedure for replacing capacitors is to heat with the soldering iron legs that are behind the motherboard and go with your other hand moving the capacitor for this loose. try not to let
empty solder holes left after removing the capacitor,
to then place the new facility.
PHOTO WITHOUT BASE PLATE CAPACITORS
READY TO FIT AND WELD NEW CAPACITORS
PUTTING NEW PICTURES
OUR MOTHERBOARD CAPACITORS
Unlike resistors, capacitors have a positive and a negative side must be placed in the right direction. Note that one leg is longer than the other: that indicates the positive side. guide can also read the jacket of the condenser.
No comments:
Post a Comment